reducer生产-朝阳reducer-圣霖国际【精益求精】

对减速机箱体进行共振测试，找出共振位 置，增加适当的筋条（板），可以提高箱体的刚度，减少箱体的振动，实现降噪。多级传动时要求瞬时传动比的变化尽量小，以保证传动平稳，reducer生产，冲击及振动小，reducer企业，噪声低。

By testing the resonance of the reducer box， finding out the resonance and adding appropriate ribs (plates)，reducer报价， the stiffness of the box can be increased， the vibration of the box can be reduced and the noise can be reduced. In multistage tran***ission， the change of instantaneous tran***ission ratio should be as ***all as to ensure stable tran***ission，朝阳reducer， low impact and vibration， and low noise.

减速机内部齿面硬度 随着齿轮硬齿面技术的发展，其承载能力大、体积小、重量轻、传动精度高等特点使其应用领域日趋广泛。但为获得硬齿面采用的渗碳淬硬使齿轮产生变形，导致齿 轮传动噪声增大，寿命缩短。

With the development of hard tooth surface technology， the internal hardness of gear reducer has been widely used because of its large bearing capacity， ***all volume， light weight and high tran***ission accuracy. But the carburizing and hardening used to obtain the hard tooth surface causes the deformation of the gear， which results in the increase of the noise of the gear tran***ission and the shortening of the service life.

在安装时，严禁用铁锤等击打，防止轴向力或径向力过大损坏轴承或齿轮。一定要将安装螺栓旋紧之后再旋紧紧力螺栓。

At the time of installation， it is strictly prohibited to use a hammer， such as a hammer， so as to prevent the axial or radial force from damaging the bearing or gear. It is necessary to tighten the bolt when the bolt is tightened.