铁岭reducer谁家好值得信赖,圣霖国际精益求精

减速机与工作机的联接：减速机直接套装在工作机主轴上，当减速机运转时，作用在减速机箱体上的反力矩，又安装在减速机箱体上的反力矩支架或由其他方法来平衡。机直接相配，另一端与固定支架联接.

The connection between the reducer and the working machine: the reducer is directly installed on the main shaft of the machine, when the reducer operates, the torque acting on the gearbox body is installed on the reverse torque support on the reduction box body or by other methods to balance. The machine is directly matched and the other end is connected with the fixed support.

在输出轴上安装传动件时，不允许用锤子敲击，通常利用装配夹具和轴端的内螺纹，用螺栓将传动件压入，否则有可能造成减速机内部零件的损坏。

When driving parts are installed on the output shaft, it is not allowed to knock with hammers. Usually use assembly jig and inner thread of shaft end to press the tran***ission parts into bolts with bolts, otherwise, it may cause damage to internal parts of reducer.

减速机内部齿面硬度 随着齿轮硬齿面技术的发展，其承载能力大、体积小、重量轻、传动精度高等特点使其应用领域日趋广泛。但为获得硬齿面采用的渗碳淬硬使齿轮产生变形，导致齿 轮传动噪声增大，寿命缩短。

With the development of hard tooth surface technology, the internal hardness of gear reducer has been widely used because of its large bearing capacity, ***all volume, light weight and high tran***ission accuracy. But the carburizing and hardening used to obtain the hard tooth surface causes the deformation of the gear, which results in the increase of the noise of the gear tran***ission and the shortening of the service life.